DC motor is a rotating motor that can convert DC electrical power into mechanical strength (DC motor) or mechanical energy into DC electrical energy (DC generator). It is a motor that can transform DC and mechanical power into 1 another. When it operates as a motor, it is a immediate existing motor, which converts electrical power into mechanical vitality when it operates as a generator, it is a immediate present generator, which converts mechanical energy into electrical energy.
|Item Identify||380V H80-355 IP55 Higher Performance 3 Stage Asynchronous Motor|
|Motor Sort||DC Motor,ACMotor,Stepper Motor,Asynchronous Motor ,Synchronous Motor
|Composition structure||The construction of DC motor ought to consist of two components: stator and rotor. The static element of DC motor is named stator. The primary operate of stator is to produce magnetic area, which is composed of foundation, main magnetic pole, commutation pole, stop cap, bearing and brush gadget. Managing part is called rotor, whose principal operate is to make electromagnetic torque and inductive electromotive drive. It is the hub of energy conversion of DC motor. So it is also generally referred to as armature, which is made up of rotor, armature main, armature winding, commutator and enthusiast.|
|Torque assortment||1.5 ~180kNm|
|Security degree||IP23, IP44|
|Running pace||Constant Pace /Reduced Speed /Change Pace /Large Speed Other|
|Main classification||DC Motor is a device that converts mechanical strength into DC electricity. It is largely employed as DC motor for DC motor, electrolysis, electroplating, smelting, charging and excitation electrical power source of alternator. Despite the fact that in places where DC power is required, AC electricity rectifier is also utilised to transform AC into DC power, but from some factors of overall performance, AC rectifier electrical power supply can not entirely exchange DC generator.|
|Software||DC motors are commonly utilized in tape recorders, online video recorders, video discs, electric shavers, hair dryers, digital watches, toys and so on.|
|Maintenance technique||Expert motor routine maintenance centre motor routine maintenance procedure: cleaning stator and rotor – changing carbon brush or other components – vacuum F pressure dipping paint – drying – Calibration balance.
1. Use surroundings must be always dry, motor surface need to be stored clean, air consumption should not be hindered by dust, fibers and other obstacles.
2. When the thermal safety of the motor proceeds to run, it ought to be ascertained whether the fault arrives from the motor or the overload or the setting worth of the protecting unit is as well low. Right after eliminating the fault, it can be put into operation.
3, make sure that the motor is properly lubricated for the duration of procedure. The general motor runs for about 5000 hrs, that is to say, lubricating grease need to be added or changed. When bearing overheating or lubricating deterioration is discovered in operation, the hydraulic strain need to adjust lubricating grease in time. When replacing grease, the previous grease need to be taken out, and the oil groove of bearing and bearing protect must be washed with gasoline. Then ZL-three lithium grease should be stuffed with one/two (2 poles) and 2/three (four poles, 6 poles and eight poles) of the cavity amongst the internal and outer rings of the bearing.
four. When the lifestyle of the bearing is in excess of, the vibration and sound of the motor will enhance naturally. When the radial clearance of the bearing reaches the pursuing benefit, the bearing ought to be changed.
five, when eliminating the motor, it is Okay to get rid of the rotor from the shaft extension or the non extension stop. If it is not needed to unload the supporter, it is much more handy to get out the rotor from the non-axle extension end. When pulling out the rotor from the stator, the stator winding or insulation need to be prevented from being damaged.
6. When changing the windings, the sort, size, turns and gauges of the authentic windings have to be recorded. When these knowledge are misplaced, they should be received from the producer and the first made windings need to be transformed at will, which frequently deteriorates 1 or a number of efficiency of the motor or even can make it impossible to use them.